Here is the solid state blinker box test:
Pin "A" to a light bulb which is grounded (I use a test light)
Pin "B" to a 24V DC source (12V will work)
Pin "C" to ground
When "B" is connected, the light should blink about 80 times per minute.
Printable View
Here is the solid state blinker box test:
Pin "A" to a light bulb which is grounded (I use a test light)
Pin "B" to a 24V DC source (12V will work)
Pin "C" to ground
When "B" is connected, the light should blink about 80 times per minute.
Another method for testing the solid-state flasher module:
http://www.m715zone.com/jonmisc/Soli...witchTest1.jpg
Method for testing the turn-signal switch:
http://www.m715zone.com/jonmisc/Soli...witchTest2.jpg
Turn-signal switch diagram:
http://www.m715zone.com/jonmisc/Soli...tchDiagram.jpg
My turn signals seem to work when they want to. I have a new flasher unit, but haven't installed it yet. Wondering if it could be the ground. One day the turn signals and emergency flashers will work, the next day not. Sometimes they work or won't work all in the same day? Any ideas?
You are on the right track. Check your grounds and all the connections. I have never had a solid state military blinker box "kind of" work. They either work or they don't.
Now, I have had a few that light up either the blinker at the fenders or blinker indicator inside and not flash. Others will just not work in any way shape or form. Either fault, is permanent and constant.
I have found that most people have no clue how to check these things and will sell or give away good ones as "bad" at shows and gatherings if you ask them for faulty ones. For some reason we just don't throw the bad ones away.
I have a bag of about 30 now. 5 have tested as good. Not bad when all were free over a few years of asking for bad ones everytime I go near military parts.
Thanks Barrman, I do occasionally have the problem of the blinker light on the steering column coming on and staying on. Sometimes I can blink it manually by moving the lever up and down. Very weird.
That is probably your blinker arm or 3 lever switch then. One of mine just goes dead on the blinker circuit until I jiggle the 3 lever. It happens with no pattern or reason too.
Thanks, I'll start with the ground. I've taken the turn signal box on the steering column apart and it looks brand new. My guess is maybe the ground on the firewall of the truck. I hate electrical problems, but I guess it's a fact of life when you own older vehicles.
Barrman,
I have a related turn signal question.
Whenever I drive, I remember to turn on the upper lamp switch one click to the right so the turn signals and the brake lights work (but not the headlights). Often I forget to turn this switch off at the end of the ride. Will leaving the switch on hurt the circuit, drain the battery, or anything bad? Will the fuse blow to "save the circuit" if there is a problem?
Thanks in advance,
When you have the old style switch with actual levers, leave it on the first click to the right all you want. Unless you leave the blinkers on or have a stuck brake light, nothing bad will happen.
However, if you have a newer push button switch. You have to push the buttons and make it turn off every night or the battery will go dead.