bluesman2a : Did I mention I HATE sheetmetal work?
Did I mention I HATE sheetmetal work?
Post by bluesman2a on May 13, 2006, 2:07pm
Little progress report, been working on repairing the large holes I had to cut to "repair" the damage from the P.O. (looks like he just beat the crap outta the firewall to "clearance" and then gnawed through the sheet with a dull gerbil where he needed a hole.
Before:
http://www.sjmembers.com/gallery/alb...0473.sized.jpg
After:
http://www.sjmembers.com/gallery/alb...0499.sized.jpg
http://www.sjmembers.com/gallery/alb...4/DSCF0497.jpg
New plate to mount forward battery-box.
http://www.sjmembers.com/gallery/alb...0498.sized.jpg
I'll tell you, while I don't much care for this work, for anybody who has to do it, .023 wire makes ALL the difference in the WORLD. I was actually able to lay a pretty decent bead and not have to "spot" everything. No warping, not a lot of heat transfer into the work piece.
I probably could have made it look a little better with some filler, but it's solid and water tight for now, that's all I care about...