Looking nice, keep the photos coming.:)
Printable View
Looking nice, keep the photos coming.:)
Need help ... Six wires B, C, D, E, F, G at direction switch and A, B wire at small solid state unit.
http://www.m715zone.com/vb/picture.p...&pictureid=910
Six wires B, K, L, J and 2x? in the car's wiring harness. How are these connected? I think I have both old and new parts of the flasher???
http://www.m715zone.com/vb/picture.p...&pictureid=911
If you read down the page where I converted my turn signal setup from the early distribution box to the later solid state style, you can see how the wires run:
http://www.m715zone.com/vb/view.php?...signal_convert
This page may help with the wires also:
http://www.m715zone.com/vb/view.php?..._switch_wiring
Then there are these as well:
http://www.m715zone.com/vb/pages/man...istboxturn.jpg
http://www.m715zone.com/vb/pages/man.../ts_switch.jpg
Thanks for the really great help brute4c. Three weeks I've been trying to understand what is not working ... I opened the flasher switch and earlyCJ5 site I found a picture of how the cables should be. ??? Differences in the pictures below. Do everyone think it's right? When I made changes... all the lights are working properly but only the flashing switch light is flashing ??? Can a solid state unit be broken?
http://www.m715zone.com/vb/picture.p...&pictureid=913
http://www.m715zone.com/vb/picture.p...&pictureid=914
Start looking GOOOOOD
http://www.m715zone.com/vb/picture.p...&pictureid=915
I would say a solid state box can go bad...anything electrical can...just havent heard of one...wish I had a spare one you could test with to check if thats it...
At last I got all the turn signals and brake lights working. I had to add two diodes and one relay. Well, now they work ... Something mystical about that turn signal, or I'm missing something ...
Now painted seats and more bolts.
http://www.m715zone.com/vb/picture.p...&pictureid=919
The passenger side is starting to be finished, and I noticed that I was missing five mounting clips to secure the damper inside the door.
Door window I installed the 3d-printed rails, Works great :)
http://www.m715zone.com/vb/picture.p...&pictureid=916
Now itīs almost finished inside the cabin. Next, the driver's side door, the paintings and the restoration of the seats.
http://www.m715zone.com/vb/picture.p...&pictureid=921
http://www.m715zone.com/vb/picture.p...&pictureid=922
Looking good