Cab floor work
Post by warthog on Jun 8, 2006, 1:16pm
All winter I had the cab in the garage and replaced the floor pans, inner/outer rocker panels, and rear corner of cab on both sides. I know I could have bought another cab to replace mine, but I wouldn't have learned anything. I learned a lot trying to figure out how to get the metal to bend the correct way or how to recreate the piece to look the same (or close to) as the original. I destroyed a new replacement full length floor pan, but got some good learnings and scrap from it. I had bought some sheet metal books, a few body hammers & dollies, and read a lot from others here and across the internet for some how to's. Thanks to those who posted their pics. Special thanks to whomever it was that did the cross bars to hold the trans tunnel, that had me stumped for a few weeks how to hold it up.
Figured it was easier to link the page, than try to paste all the pics in. Here's a link to some pics I put on photobucket:
Driver side:
http://s35.photobucket.com/albums/d183/w..../Driver%20side/
Passenger side:
http://s35.photobucket.com/albums/d183/w....rk/Pass%20Side/
Figured ya'll might be interested in these pics.
Dan