Looking for thickness ,width,and height on the channel bracket that the back of the winch bolts to?
Looking for thickness ,width,and height on the channel bracket that the back of the winch bolts to?
That is a pretty complex piece of steel. It isn't channel iron. It isn't 3 sided square tubing either because each side is bent just a little in different ways. I have one on a truck here in my class with the winch all installed so pictures will be useless. I can give you the basics, but without a press brake. A big press brake this will be hard to make.
Remember if you didn't build it you can't call it yours.
6.2 powered M715, 5 M1009's, M416, 2 M101's, 2 M105's, 3 M35's, M1007 6.5 turbo Suburban project called Cowdog.
https://www.youtube.com/channel/UCCz...HGkBCfhXZ5iuaw
Yes, just the general sizes would be great. I can brake up to 1/4 on something that long.
and if there was a way I could get a good pic or three of the pto driveline that would be great.
Site Upgrade, Design Modifications & Administrative Support by: Palm River Enterprises LLC, IT Solutions President: Tom King, User ID=teking |
This site is owned and operated by: M715 Zone, LLC President: Jon Schmidt, User ID=brute4c |
Copyright Notice: This web site is subject to the protection of the copyright laws of the United States and other countries. Except for Personal Use Only, you may not modify, copy, distribute, transmit, display, perform, reproduce, publish, license, create derivative works from, transfer, or sell any information obtained from any part of the M715 Zone website without the prior written permission of M715 Zone, LLC. Written permission can only be obtained by contacting brute4c@m715zone.com |