Heat'n and Beat'n
Post by snuffy on Jun 9, 2006, 5:35pm
I'm straightning out the fenders...
Anyone know the radius of the wheelwell/fender?
I've got an idea... and it will make this a lot easier! We have a company we get to plasma cut (computer guided) sheet steel for us. If they cut (60% of) a circle the same size (x 2) and I weld them together with 5 inch spacers in them, I have a pattern for a straightened fender. Set the fender over the pattern and get the torch and hammer!!!! Looking @ 11 ga. Open to suggestions....
Snuffy