What to use? Close to finishing.
Post by porkchop on Aug 7, 2006, 7:15pm

I am at the point where I need to get a coil. Now I know they don't make a 24V coil other than the water proof type used on the M-trucks. I was told a while back that I could use a 3.0 ohm coil and a inline 3.0 ohm resistor and it will work fine with the 24 volt system. I have also thought about getting a small convertor to use for the coil only. That is my last real hurdle. I hope.

I figure for the starter just get a 24v selinoid. They sell them here in town. Anyone see any problems with this?