Who was it that posted about making the trans adapter? Jed maybe? What issues were there with input shaft, etc? Thanks, Bill
Who was it that posted about making the trans adapter? Jed maybe? What issues were there with input shaft, etc? Thanks, Bill
A guy down in Bee Branch, Arkansas made a couple for his trucks to go from the T98 to a Chevy 350-8 and a Ford 300-6. What he made was a plate that bolted to the back of the bellhousing for the new motor and a plate that bolted to the front of the trans...then he measured what length was left to fill and welded a piece of pipe between of about 4 inch diameter.
Not really that hard...wish I had gotten a pic...
.008 runout is max. otherwise it will kill bearings and clutch discs.
Also need to mount a front bearing retainer to the front of the adapter for the throwout bearing, and make sure it is centered on the adapter to line up with the bell housing. Not a real difficult project, but precision certainly counts.
to make this correctly is alot more complicated than you think. if its made wrong it will cost you a bunch of money , parts & labor.
bob
It's not rocket science though. Proceed VERY CAREFULLY!!! but do not be afraid.
There are a ton of guys running homebrew adapters here: t-case, tranny, what have you. None of them are rocket scientists. Well, one guy actually IS-- works at Thiokol, but he's the only one.
**I heart Bump_r **
Thanks for the info
Here's what my adapter looks like...Just like Brute described
Sae basic idea...instead of a round piece bridging the 2 plates yours is square...no big diff.
No machining for a front bearing retainer to the front of the adapter for the throwout bearing...nothing on the inside to make...just what you see on the outside and hollow inside.
Kaching!!! That's the pic I was looking for. Any problem with the runout like Bob was mentioning? I could have it surface milled at work after welding if that were a big issue.
Site Upgrade, Design Modifications & Administrative Support by: Palm River Enterprises LLC, IT Solutions President: Tom King, User ID=teking |
This site is owned and operated by: M715 Zone, LLC President: Jon Schmidt, User ID=brute4c |
Copyright Notice: This web site is subject to the protection of the copyright laws of the United States and other countries. Except for Personal Use Only, you may not modify, copy, distribute, transmit, display, perform, reproduce, publish, license, create derivative works from, transfer, or sell any information obtained from any part of the M715 Zone website without the prior written permission of M715 Zone, LLC. Written permission can only be obtained by contacting brute4c@m715zone.com |