Steering column and headlight switch

[fisherman]

Just about ready to shoot some final parts green before assembly. I was wondering if anyone has a part number for a 12 volt headlight high/low switch that will mount in the bracket on the floor to replace the factory one. Also my steering shaft joint where the rubber boot is, well the boot is torn. Is there a part number or place I can get a new boot? Or what have others done to keep the grease in?? Thank You .

[LuckyPabst]

The hi-beam dipper switch dosen't care what voltage you put through it (to a point). You'll be fine with the stocker as long as it was OK to begin with.

Chris

[george walker]

the boot is f.s.n.5330-147-8446 jeep#11657577 ck w memphis or VPW and remember to put grease back inside the cup when you reassemble and you can look up parts right on this site use the manuals link at the page header to download the factory manuals parts and service

[fisherman]

The switch worked a few years ago, but it is sticky. Wanted to go with a new one.

[Binford]

I pulled my switch (also sticking) and blasted it out with Gun Scrubber I think. Then I gave it a shot of Kroil when the cleaner dried, and worked it a bunch to get it all loosened up. Really made a big difference.