xjchief : Exhaust Manifold and system

[PseudoZone]

Exhaust Manifold and system
Post by xjchief on Sept 30, 2006, 4:25pm

Finally got most of the parts together to replace the stock exhaust from the block back. I've removed half the pipe but am stalled on the manifold. The studs are all backing out instead of the nuts on the studs. I've never replaced one of these before so I was wondering if this is okay of if I need to replace the studs and the nuts now. Also, any suggestions regarding antisieze or lock tight?

Like I said, never done this before and don't want to mess it up.

Thanks for the help.

XJ

[PseudoZone]

Re: Exhaust Manifold and system
Post by koobster on Sept 30, 2006, 4:30pm

so did mine this morning 2 of the studs stayed in. When U put them back in just make sure they are tight

[PseudoZone]

Re: Exhaust Manifold and system
Post by xjchief on Oct 1, 2006, 10:35am

Okay, I'd like to replace the studs. They look pretty bad. A trip to Napa, Advanced, Autozone, leaves me empty handed. Does someone know where I can get a set?

[brute4c]

Re: Exhaust Manifold and system
Post by brute4c on Oct 1, 2006, 2:29pm

Hmmm...I took a long and ashort one to Napa and got all that I needed...they arent too oddball...

[PseudoZone]

Re: Exhaust Manifold and system
Post by xjchief on Oct 1, 2006, 5:46pm

Ace Hardware had some that are almost an exact replacement.