Results 1 to 3 of 3

Thread: Install new oil pump

  1. #1

    Default Install new oil pump

    Could someone please confirm my options for priming an oil pump. I replaced my oil pump and am installing it while the engine is whole and in place.

  2. #2
    Join Date
    Jun 2014
    Location
    Eastern Maine
    Posts
    377

    Default

    Spin the engine over with the ignition switch off.

  3. #3

    Default

    I injected motor oil into my freshly rebuilt Tornado (with empty oil galleries) through the oil pressure sending unit hole using a new, small garden sprayer.
    I done this until I seen oil seeping out of the camshaft.

    But yes, just to prime a new oil pump, you can spin the engine over until you see oil pressure. I would remove all the spark plugs before doing it, allowing the engine to spin easier and to reduce any strain on the rod bearings
    Last edited by jeepdan; August 1st, 2019 at 10:29 AM.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


Site Upgrade, Design Modifications & Administrative Support by:
Palm River Enterprises LLC, IT Solutions
President: Tom King, User ID=teking
This site is owned and operated by:
M715 Zone, LLC
President: Jon Schmidt, User ID=brute4c


If you have any suggestions, comments, problems or questions, contact:  brute4c@m715zone.com
Use of this site means you understand and agree to our TERMS OF USE

Copyright Notice:
This web site is subject to the protection of the copyright laws of the United States and other countries. Except for Personal Use Only, you may not modify, copy, distribute, transmit, display, perform, reproduce, publish, license, create derivative works from, transfer, or sell any information obtained from any part of the M715 Zone website without the prior written permission of M715 Zone, LLC. Written permission can only be obtained by contacting brute4c@m715zone.com

Copyright 1998-2024