Divorced tranny to Turbo 400 drive shaft question
Post by elohim1 on Jun 22, 2006, 7:23pm

I am committed to using a divorced 205 to a 2wd turbo400. The fellow I bought the tranny off of sent me a tranny that would bolt directly to a NP205. He said he will send me the housing to put on the end so the th400 will accept a yoke. I have the deuce drive shafts which has the 1410 yokes. One of the deuce shafts has real large yokes which I will use for the rear.

I was planning on cutting one of the deuce shafts down which has the 1410 yokes, to run in between the 205 and th400.

This will make it a 1410 at the T-case and tranny.

The fellow said he didnt know if he had any 1410 yokes, he did say he had 1530, however that will not work with my shafts.


Question

1) Is there a bolt on 1410 yoke made for the TH400?

2) should I use a slip joint in the jack shaft?

3) Should I use some other setup that I am not aware of at the th400?

Thanks
Chris