Results 1 to 10 of 40

Thread: Rear Axle Swap Dana 70u from Jeep CJ10A Tug

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. #1

    Default Rear Axle Swap Dana 70u from Jeep CJ10A Tug

    This is a work in progress but I just wanted to post a few pics of an axle swap. I'm using a Dana 70u out of a mid 80's CJ10A airplane tug. It has 4.88 gears and a powerlok. The WMS to WMS is 75.5", so it is an inch wider than the stock axles (73.5") on each side. I'm planning on using H1 rims with it.

    Sorry these are ugly cell phone pics, but it was all I had. I'm having a local 4wd shop do the work.



    The stock drums on the tug axle are stamped with Ford logos, so I bought a Ford Dana 70u disc brake bracket from Ruff Stuff Specialties http://www.ruffstuffspecialties.com/...roducts_id=214. They bolted to the existing backing plates and lined up perfect.


    You can see how much space there is between the stock springs and the brakes. If you wanted you could probably use the stock drums that come on these axles.



    The center section is in the center of this axle. So the clearance between the gas tank and driveshaft is pretty tight. Right now the gas tank is about 1.5" away from the inner edge of the frame. I think once it gets tucked over against the frame the driveshaft will have enough room. May still need to bend or trim the very edge/corner of the tank by the driveshaft. You can also see in this pic how the bottom of the 70u is very smooth with no bottom lip protruding to hang up on rocks or whatever else you like to run over.


    A Dana 60 from a M1008 will go up front, spring under, using the stock springs. It has 4.88 gears swapped in and ballistic fab high steer arms for the steering. Will also be putting DRW hubs on it to use the H1 wheels. They will be doing something similar to bluesman2a and wantapinz for the spring perches on the front axle. Waiting on spring bushings for the stock front springs right now.

    I'll post more pics hopefully in a few weeks when it is done.
    Last edited by jlogan; January 15th, 2011 at 10:10 PM.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


Site Upgrade, Design Modifications & Administrative Support by:
Palm River Enterprises LLC, IT Solutions
President: Tom King, User ID=teking
This site is owned and operated by:
M715 Zone, LLC
President: Jon Schmidt, User ID=brute4c


If you have any suggestions, comments, problems or questions, contact:  brute4c@m715zone.com
Use of this site means you understand and agree to our TERMS OF USE

Copyright Notice:
This web site is subject to the protection of the copyright laws of the United States and other countries. Except for Personal Use Only, you may not modify, copy, distribute, transmit, display, perform, reproduce, publish, license, create derivative works from, transfer, or sell any information obtained from any part of the M715 Zone website without the prior written permission of M715 Zone, LLC. Written permission can only be obtained by contacting brute4c@m715zone.com

Copyright 1998-2024